How many studs do I need for a wall?
Start with the stud layout: divide the wall length in inches by the stud spacing, round up, and add one for the end. A 12-foot wall at 16" on center needs 144 รท 16 = 9, plus 1 = 10 studs. Then add:
- 2 king studs and 2 jack studs for each door or window.
- Cripple studs above each header and below each window sill, on the regular layout.
- 2 extra studs for each corner or place another wall meets this one.
- Plates: one bottom plate and two top plates the length of the wall.
The calculator above lays the studs out the way a framer would (first stud flush with the end, then centered every 16" or 24"), places your openings, and counts every piece in that exact layout. Studs that land inside a door or window become cripples instead of full studs.
Studs per foot of wall
| Spacing | Base studs | 10 ft wall | 20 ft wall |
|---|---|---|---|
| 12" on center | 1 per foot + 1 | 11 | 21 |
| 16" on center | 0.75 per foot + 1 | 9 | 16 |
| 19.2" on center | 0.625 per foot + 1 | 8 | 14 |
| 24" on center | 0.5 per foot + 1 | 6 | 11 |
These are straight walls with no openings. A quick rule of thumb for estimating is one stud per linear foot of wall at 16" on center, which roughly covers corners, openings and a few spares.
Parts of a framed wall
- Bottom plate (sole plate): the horizontal board nailed to the floor.
- Top plates: usually doubled. Joints in the two top plates should be staggered, and most codes require at least 24" between them.
- Studs: full-height verticals on the regular layout.
- King studs: full-height studs on each side of an opening.
- Jack studs (trimmers): shorter studs against the kings that carry the header.
- Header: the beam over a door or window, usually two boards on edge with a spacer between them.
- Cripple studs: short studs above a header or below a window sill.
- Rough sill: the flat board at the bottom of a window opening.
Frequently asked questions
How do you calculate how many studs you need for a wall?
Divide the wall length in inches by the stud spacing, round up, and add one. A 12-foot wall at 16 inches on center needs 144 รท 16 = 9, plus 1 = 10 studs. Then add two king studs and two jack studs for each door or window, cripples above and below openings, and two extra studs for each corner or wall intersection.
How many studs per foot of wall?
At 16 inches on center the base count is 0.75 studs per foot of wall, plus one. Builders often estimate one stud per linear foot of wall to cover corners, openings and spares. At 24 inches on center the base count is 0.5 studs per foot.
Should studs be 16 or 24 inches on center?
16 inches on center is the most common spacing and is standard for 2x4 walls. 24 inches on center uses fewer studs and is common for 2x6 exterior walls. Which spacing is allowed depends on the wall height, the load it carries and your local building code.
What is the difference between king, jack and cripple studs?
King studs run full height on each side of a door or window. Jack studs (trimmers) sit against the king studs and hold up the header. Cripple studs are short studs above the header and below a window sill that keep the stud layout going.




